中卫科目四英语电子版

1. When encountering non-motorized vehicles cutting in on the road, the driver should ________.

A. Honk to warn

B. Speed up and bypass from the front

C. Voluntarily reduce speed and yield

D. Suddenly speed up when approaching

Answer: C

2. What is the meaning of this sign?

A. Hump bridge

B. High outburst road

C. Low-lying road

D. Bump road

Answer: A

3. When a motor vehicle encounters a burning phenomenon, it should leave the vehicle quickly so as not to cause injury or asphyxia to the respiratory tract.

A. Right

B. Wrong

Answer: A

4. When approaching another vehicle at night, why should the driver alternate between high-and-low-beam at a distance more than 150 meters?

A. Warn each other before passing

B. Driving habit

C. Easy to observe the situation ahead from either side

D. Courtesy

Answer: C

5. After a traffic accident, what is the most effective measure to prevent secondary accidents?

A. Evacuate all passengers

B. Turn on the hazard lamps

C. Mark the original place of the injured persons

D. Properly place the danger warning sign

Answer: ABD

6. When an erosive material catches fire, it should not be put out with water cannon.

A. Right

B. Wrong

Answer: A

7. What is the meaning of this sign?

A. Crosswalk lights

B. Watch for pedestrians

C. Attention to traffic lights

D. Intersection

Answer: C

8. The continuously flashing yellow light is to warn that the driver should look and make sure it is safe to pass.

A. Right

B. Wrong

Answer: A

9. You can make an U turn at this intersection.

A. Right

B. Wrong

Answer: B

10. When driving on a road covered with ice and snow, drivers tend to encounter glare caused by reflection of light rays from the road surface.

A. Right

B. Wrong

Answer: A

11. Where can not park?

A. Parking lot

B. Parking spaces on roads

C. Landslide and debris flow in Mountainous Areas

D. Crosswalk

Answer: CD

12. The motor vehicle should speed up and pass rapidly under this situation.

A. Right

B. Wrong

Answer: B

13. When approaching a sharp curve, motor vehicle drivers should reduce speed only after entering the curve.

A. Right

B. Wrong

Answer: B

14. Whats the meaning of the double white broken lines in far front of the intersection?

A. Waiting to run line

B. Stopping and yield line

C. Slowdown and yield line

D. Left-turn waiting line

Answer: C

15. What is the meaning of this sign?

A. Watch for long time honking

B. An unmanned level crossing

C. A manned level crossing

D. Multi-crossing of railway and road

Answer: B

16. When overtaking a motor vehicles on uphill sections of a mountain road, the driver should _____.

A. Honk in advance

B. Forward cars are allowed to overtake before overtaking.

C. Turn on the left-turn signal in advance

D. Speed up direct and overtake

Answer: ABC

17. When the vehicles cross each other at night, what should the driver do if the vehicle coming in the opposite direction don’t turn off the high beam light?

A. Reduce speed for yield or stop on the right side.

B. Continuous change lights to remind the vehicle coming in the opposite direction

C. Turn on the high lights and force the coming car to change the lights

D. Move his sight to the right side to evade the light

Answer: ABC

18. Keep enough safe distance When a motor vehicle follows another vehicle, because ______.

A. Avoke a rear-end collision

B. The closer you get to the vehicle, the less easy it is to grasp the situation ahead of the vehicle.

C. Enough distance to avoid emergencies

D. Prevent being unable to detect the front vehicle brake in time due to the damage rear lamp of the front vehicle

Answer: ABCD

19. When driving on a damp and slippery road, drivers should avoid using the emergency brake to his/her best ability.

A. Right

B. Wrong

Answer: A

20. When approaching a vehicle on a narrow slope, which one of the following ways is correct?

A. The descending vehicle yields to the ascending

B. The vehicle which is further from the slope crest should yield

C. The ascending vehicle yields to the descending

D. If the descending vehicle has reached the midpoint while the ascending vehicle has not yet set out, the descending vehicle must yield.

Answer: A